Calibration Procedure for the Throttle Jockey
 

This procedure only needs to be performed on initial installation or when the Governor is moved to another heli.

Make sure that any aux mixing is disabled and the ATVs of the throttle and aux channels are as close to 100% as possible.

1. Put the throttle stick and trim to the low position.

2. Turn the transmitter on and then the receiver.

3. Toggle the auxiliary switch twice within the first 3 seconds after turn on, the greed LED will flash.

4. Raise the throttle high and then low again.

5. Toggle the auxiliary switch twice, the greed LED will turn off.