The throttle connects to channel (3)

The auxiliary connects to the GOVERNOR channel (7)

End Point Adjust [END POINT]

Setup the throttle with the E.POINT range as close to 100/100 as possible.

Select channel 7 (AUX) and set the [E.POINT] to 100/100

Make sure that the [GOVERNOR] function is inhibited [INH] before calibration. (See page <2/2> in the GOVERNOR menu).

The system is now ready for calibration. Calibration Procedure

The target rotor speed can be calculated using the EPA Calculator

Note: The 9C has a Governor function. The EPA values for rotor speed must be converted to Governor rates by dividing by 2 and adding 50. A rate of 50 disables the Throttle Jockey, An EPA of 53 (1500 rpm @ 9.3) corresponds to a rate of 53/2 + 50 = 76.5.

Enable the Governor function:

In the [ADVANCE(HELI)] menu select GOVERNOR

Page <1/2>

RATE-UP        > 76.5%      (53/2 + 50)

          CNTR   > 64.5%       (29/2 + 50)

          DOWN > 50.0%

Select SW>C

Page <2/2>

Change MIX>INH to MIX>ACT

CUT-CH>CH7

DIR>+Limit

 This will yeild the following results:

SW(C)                       Rotor RPM @ 9.3:1

Up                             1500rpm

Center                        1200rpm