JR PCM 10X SetupThe throttle connects to THRO channel (1)
The auxiliary connects to AUX2 channel (7)
Make sure that any mixing on AUX2 is off.
Activate the AUX2 switch in the [17.FUNC.S.] menu.
ATV setup [12.TRAVEL]
Setup the throttle servo and linkage as
close to +/- 100% ATV as possible.
Select the AUX2 channel to +100% and -100%
Hint: You can observe the AUX2 range on the [75.SERVO.M] screen
The system is now ready for calibration.
Calibration Procedure
The target rotor speed can be calculated using the
ATV Calculator
Example 1): 2 speed setup:
Gear ratio = 9.3:1
ATV- = 39%, ATV+ = 72%
AUX2 Sw Posn Rotor RPM
(DOWN) 1200
(UP) 1500
Example 2): 1 speed setup and disable:
Gear ratio = 9.3:1
ATV- = 0%, ATV+ = 72%
GEAR Sw Posn Rotor RPM
(DOWN) Disabled
(UP) 1500
Example 3): Flight Mode Mixing:
Set the throttle curves in Flight
modes 1 and 2 above the throttle priority level.
Set the AUX2 switch to the down position
Set the AUX2 ATV [TRVL ADJ] to -0%
Set the AUX2 switch to the up position
Set the AUX2 ATV [TRVL ADJ] to +100%
Perform the following mix setups with the AUX2 switch in the UP
position.
[51.PGM.mix1] - This mix disables the Governor in flight mode 'N'
AUX2->AUX2
NORM
OFFSET 0
-100% (Press the [TURN] to change the sign)
+0%
[page]
NR ACT and S1 ACT and S2 ACT
[52.PGM.mix2] - This mix sets the target rpm to 1200rpm (39%) in
flight mode '1'
AUX2->AUX2
NORM
OFFSET 0
+39%
+0%
[page]
S1 ACT only
[53.PGM.mix3] - This mix sets the target rpm to 1500 (72%) in
flight mode '2'
AUX2->AUX2
NORM
OFFSET 0
+72%
+0%
[page]
S2 ACT only
AUX2 Sw Posn Flight Mode Rotor RPM
Down N
Disabled
1
Disabled
2
Disabled
Up N
Disabled
1
1200 rpm
2
1500rpm